TM 5-3610-253-14
This equipment is designed for operation only in a controlled environment.
OPERATOR MAINTENANCE
Section III
operator level of maintenance.
5-9. TROUBLESHOOTING PROCEDURES.
a. The table lists the common malfunctions which you may find during operation or
maintenance of the paper cutter, or its components. You should perform the
test/inspections and corrective actions in the order listed.
b. This manual cannot list all malfunctions that may occur, nor all test or
inspections and corrective actions. If a malfunction is not listed or is not
corrected by listed corrective actions, notify your supervisor.
SYMPTOM INDEX
PAGE
TROUBLESHOOTING
PROCEDURE
CUTTING
Machine Does Not Cut Through Material . . . . . . .
Bottom Sheet of Material is Cut Only on One Side or
Not At All . . . . . . . . . . . . . . . . . . .
Overcut. . . . . . . ., . . . . . . . . . . . . .
Undercut. . . . . . . . . . . . . . . . . . . . . . . . .
Bow or Hollow Cuts. . . . . . . . . . . . . . . .
Stepped Cuts . . . . . . . . . . . . . . . . . . .
Notched Cuts
Bottom Sheet Slides Under Backgauge Rakes. . . . . . . . . . .
CLAMPING
Knife Pulls Sheets Out From Under Clamp During a Cut
Clamp Does Not Descend Completely When Using Foot Pedal : : : : : :
LIGHTING
Fluorescent Table Lamp Does Not Come On . . . . . . . . . . . . . .
OCL Absent . . . . . . . . . . . . . . . . . . . . . . . . . . . .
OCL Too Wide or Fuzzy. . . . . . . . . . . . . . . . . . . . . . .
OMI
OMI Indication is Not Correct . . . . . . . . . . . . . . . . . .
Image in OMI is Not Clear. . . . . . . . . . . . . . . . . . . .
OMI Not Illuminated or Dim. . . . . . . . . . . . . . . . . . .
