TM 5-3610-253-14
Table 5-6. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
6. STEPPED CUTS ARE OBTAINED.
Step 1. Check that material is properly jogged.
(a)
If not, jog material.
(b)
If jogged properly, proceed to step 2.
Step 2. Check clamp pressure.
If clamp pressure is low, increase clamp pressure by
(a)
depressing clamp pressure control pedal.
(b)
If malfunction persists, refer to organizational mainte-
nance.
7. NOTCHED CUTTING LINE OBTAINED.
Check for foreign object in cutting material, or nicks in knife.
(a) If foreign object is in cutting material, remove it.
(b) If knife has nicks, refer to organizational maintenance for
replacement of knife (paragraph 5-16.13).
