TM 5-3610-253-14
Table 5-6. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. OVERCUT DURING THE CUT. THE KNIFE MOVES FORWARD IN THE MATERIAL SO THAT THE
LOWER SHEETS OF THE MATERIAL ARE LONGER - Cent
(a) If it is below 1500, then increase clamp pressure by moving
clamp pressure control pedal down one or two notches.
Check again for overcut.
NOTE
Different materials require different clamp pressures. Refer to
(b) Repeat step 2 until clamp pressure control pedal has been
fully depressed.
(c) If malfunction persists, refer to organizational mainte-
nance.
4. UNDERCUT DURING THE CUT. THE KNIFE MOVES BACK INTO THE MATERIAL SO THAT THE TOP
SHEETS OF THE MATERIAL ARE LONGER.
Step 1.
Check that material is properly jogged.
(a) If not, jog material.
(b) If jogged properly, proceed to step 2.
