TM 5-3610-253-14
f. If multiple cuts are to be made at different lengths, set the backgauge side
rakes as follows:
(1) Remove alinement pin from side rake being adjusted.
(2) Loosen locking bolts on side of rake.
NOTE
It may be necessary to remove the locking bolts and place them in another
hole to obtain proper setting.
(3) Set rake to desired position.
(4) Tighten locking bolts.
Place paper against backgauge.
g.
NOTE
q Be sure paper is fitted tightly against the backgauge rakes and the side
of the table.
q Make like paper cuts from same side of knife assembly.
h. Refer to table 5-5 for information on setting clamp pressure and the use of
the false clamp.
5-56