TM 5-3610-253-14
SYMPTOM INDEX - Cont
PAGE
TROUBLESHOOTING PROCEDURE
BACKGAUGE
Measured Backgauge Position and OMI Are Not In Agreement. Adustment
Does Not Correct Problem, or Backgauge Position Does Not Stay
Set. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 5-6. TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. MACHINE DOES NOT CUT THROUGH MATERIAL.
Check thickness of material.
Step 1.
(a) If material is too thick, reduce height of material to be
cut .
(b) If not, proceed to step 2.
Check to make sure material being cut is not too hard.
Step 2.
(a) If material is too hard, do not attempt to cut material.
Equipment damage may occur.
(b) If malfunction persists, refer to organizational mainte-
nance.
2. BOTTOM SHEET OF MATERIAL IS CUT ONLY ON ONE SIDE OR NOT AT ALL.
Check cutting stick for deep cuts.
(a) If cutting stick has deep cuts, rotate or replace cutting
stick (paragraph 5-10.3).
(b) If malfunction persists, refer to organizational mainte-
nance.
