TM 5-3610-253-14
Table 56. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
8.
BOTTOM SHEET SLIDES UNDER BACKGAUGE RAKES.
Check to be sure there is no gap between bottom front of backgauge rake and
table surface. (Surfaces must mate flush).
Set correct backgauge rake spring tension, by screwing tension
bolt in as far as it will go (until coils of spring touch each
other), then loosen it 1/2 turn.
9. THE KNIFE IS PULLING SHEETS OUT FROM UNDER THE CLAMP DURING A CUT.
Step 1.
Check to see if the cutting material is too soft and spongy.
