TM 5-3610-253-14
r.
If the backgauge rakes were set at different lengths, reset them as follows:
(1) Loosen the locking bolts.
NOTE
It may be necessary to remove the locking bolts and place them in another
hole to obtain proper alinement.
(2) Reposition the side rakes so that all rakes are al ined.
(3) Insert the alinement pin in through the side rakes. Tap pin into place
to be sure side rake is properly positioned.
(4) Tighten locking bolts.
s.
Turn main power switch to O position.
t.
Using operator key, lock the safety lock.
u.
Turn off circuit breaker.
5-59