TM 5-3610-253-14
k. Reinstall main drive V-belt cover.
l.
Place operator key back into safety lock.
5-36.15 Adjust Backgauge.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS: 2.5 mm Hex Head Key Wrench
4 mm Hex Head Key Wrench
6 mm Hex Head Key Wrench
SUPPLIES: Ream of Paper approximately 5 cm (2 in.) in height,
76.2 cm (30 in.) in length, and 40 cm (10 in.) in width
a.
Turn on circuit breaker.
b. Using operator key, unlock safety lock.
c.
Turn on power.
(1) Turn main power switch to I position.
(2) Turn Star-Delta swich to Y position. After main motor has reached
full speed, turn switch to
position.
(3) Press control power on switch.
d. Move backgauge forward or backward as required until backgauge position
is displayed on measurement display.
WARNING
Be sure personnel and foreign materials are clear of the cutting and
clamping area before pressing the cutting buttons. Death or
serious injury may occur.
Always keep the largest area of the material being cut behind the knife.
If the larger area is in front of the knife, it could fly up and cause
serious injury.
NOTE
Ream of paper must be even on all sides.
e.
Place ream of paper onto cutting table and position backgauge so that
approximately 12.7 mm (1/2 in.) of paper will be cut.
f. Be sure the paper is fitted tightly against backgauge.
5-448
