TM 5-3610-253-14
Lower clamp using clamp foot pedal.
g.
h.
Pressing both cutting buttons, cut paper.
i.
Release clamp foot pedal and raise clamp.
Take half of cut ream (under clamp) and turn it 180.
j.
k. Place material on top of the remaining half in the machine making sure
both materials are resting accurately and tightly against the backgauge.
NOTE
The side on which the lower half of the ream is wider than the top half
is the side that the adjustment screw must be turned to the right. However,
the opposite screw always has to be turned back the same amount.
l.
Loosen set screws on adjustment screws.
m.
Adjust screws as necessary.
n.
Repeat steps e. - m. until properly adjusted.
o.
Secure adjusting screws by tightening setscrews.
Loosen set screw on adjustment screw knob.
p.
5-449
