TM 5-3610-253-14
d. Move backgauge forward or backward as required until backgauge position
is displayed on measurement display.
NOTE
Be sure the measurement display is adjusted correctly (paragraph 5-40.60).
It will be necessary to manually move the backgauge using the backgauge
control knob to position the backgauge to the stops.
Position the backgauge to 94.50 cm (37.20 in.).
e.
WARNING
Always keep clear of moving parts while performing this task. Serious
injury may occur.
f. Remove oil drip pans under the table spindle.
NOTE
It may be necessary to move the backgauge forward in order to adjust the
stop bolt.
Loosen locknut and adjust rear stop bolt to proper setting.
g.
h. Repeat steps e. through g. until proper adjustment is obtained.
i.
Tighten locknut.
5-452
