TM 5-3610-253-14
Position the backgauge to 1.95 cm (0.76 in).
j.
NOTE
It may be necessary to move the backgauge back in order to adjust the
stop bolt.
Loosen locknut and adjust front stop bolt to proper setting.
k.
Repeat step j. and k. until proper adjustment is obtained.
l.
Tighten locknut.
m.
NOTE
Adjust limit switches to the following specifications:
93.50 cm (36.81 in.)
Backward limit switch (S13)
8.80 cm (3.46 in.)
Forward limit switch with false
clamp installed (S8)
2.40 cm (.94 in.)
Forward limit switch without false
clamp installed (S9)
Move the backgauge either forward or backward (depending on what switch
n.
you are adjusting) until it stops automatically. (Do not manually
position backgauge.)
Note the position on the measurement display.
o.
Move the backgauge away from the limit switch.
p.
NOTE
It may be necessary to adjust the nylon cams to obtain proper adjustment.
To adjust cams, loosen two hex head bolts. Use care to only move the cam
you are adjusting.
Adjust the limit switch by loosening two screws at the front of the
q.
switch and move the switch in (to stop sooner) or out (to stop later).
Repeat steps n - q until proper adjustment is obtained.
r.
s.
Repeat steps n - r for remaining limit switches.
t. Reinstall oil drip pans.
5-453