TM 5-3610-253-14
d.
To replace lamp ballast, proceed as follows:
(1) Remove eccentric cover.
(2) Remove ballast mounting bolts and defective ballast.
(3) Tag and disconnect wires from defective ballast.
(4) Reconnect wires to new ballast.
(5) Install new ballast and secure with mounting bolts.
(6) Reinstall eccentric cover.
(7) Place operator key back into safety lock.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS:
Flat Tip Screwdriver
19 mm Combination Wrench
WARNING
Death or serious injury may occur from electrical shock unless power is
turned off before servicing.
a. Turn off power.
(1) Turn Star-Delta switch to Y position, then to O position.
5-446
