TM 5-3610-253-14
(4) Press both cutting buttons again and raise the knife.
(5) Place a sheet of paper under the knife at both ends.
(6) Press both cutting buttons and perform a cut.
(7) If both pieces of paper were not cut, loosen locknuts on turn-
buckle and rotate turnbuckle 1/4 of a turn, then tighten locknuts.
(8) Repeat steps (1) through (7) until proper adjustment is obtained.
ai. Press in clamp pressure adjustment knob and step on clamp foot pedal
to lower clamp fully. Then release clamp foot pedal to raise clamp.
aj. Turn off power.
(1) Turn Star-Delta switch to Y position, then to O position.
(2) Turn main power switch to O position.
(3) Using operator key, lock the safety lock.
(4) Turn off circuit breaker.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS:
19 mm Combination Wrench
SUPPLIES: Shear Bolt
WARNING
Death or serious injury may occur from electrical shock unless power is
turned off before servicing.
a.
Turn off power.
(1) Turn Star-Delta switch to Y position, then to O position.
(2) Turn main power switch to O position.
(3) Using operator key, lock safety lock and keep key in your
5-442
