TM 5-3610-253-14
Turn main power switch to O position.
g.
h. Remove manometer from bleed port.
i. Reinstall bleed port cap onto bleed port.
Adjust Clamp Guiding.
MOS: 83FJ6, Reproduction Equipment Repairer
9 mm Combination Wrench
TOOLS:
19 mm Socket with 3/8 in. Drive
SUPPLIES: Spacer Foils
a. Turn on power.
(1) Using operator key, unlock the safety lock.
(2) Turn main power switch to I position.
(3) Press the control power on switch.
b. Using the clamp foot pedal, lower the clamp onto the table.
WARNING
Always keep clear of moving parts while performing this task. Serious
injury may occur.
c.
Be sure that the clamp is parallel to the table. If not, adjust clamp
d. Perform several clamping operations using the foot pedal. If the
guiding of the clamp is still too stiff, continue or go to step i.
5-284