TM 5-3610-253-14
f. Perform a cut and observe the reading on the manometer. If pressure is
not 65 bar (925 psi) adjust clutch pressure relief valve as follows:
(1) Remove front electronics enclosure cover and right pi llar cover.
(2) Remove capnut from clutch pressure valve.
(3) Loosen locknut and rotate hex socket adjusting screw right to
increase pressure or left to decrease pressure.
(4) Repeat step f. as necessary until pressure is 65 bar ( 925 psi).
(5) Tighten locknut on clutch pressure valve.
(6) Reinstall capnut.
(7) Reinstall front electronics enclosure cover and rightpillar
cover.
5-283
