TM 5-3610-253-14
b. Remove main motor V-belt cover.
c. Remove side reservoir cover plate and gasket.
d. Place rags around electronics to protect them from possible hydraulic
fluid splash.
e.
Turn on power.
(1) Using operator key, unlock the safety lock.
(2) Turn main power switch to I position.
(3) Press control power on switch.
WARNING
Be sure personnel and foreign materials are clear of the cutting and
clamping area before pressing the cutting buttons. Death or serious
injury may occur.
f. Perform three cutting cycles.
Loosen the capnut on the bleed port for clamp.
g.
5-286
