TM 5-3610-253-14
f. Set clamp pressure control to minimum pressure.
Perform a cut and observe the reading on the manometer. If pressure is
g.
not 32 bar (455 psi), adjust clamp pressure as follows:
(1) Remove front electronics enclosure cover and right pillar cover.
(2) Loosen the ring nut around the valve (behind the plunger).
(3) Adjust the valve housing in for more pressure or out for less
pressure.
(4) Tighten the ring nut around the valve.
(5) Repeat step g. until pressure is 32 bar (455 psi).
h. Set clamp pressure control to maximum pressure.
5-280
