TM 5-3610-253-14
Add foils behind the guiding plate until the clamp moves freely without
e.
play.
f. Adjust the side ledge by loosening the fixing screw and rotating the
adjusting screw; then tighten the fixing screw.
Perform several clamping operations using the foot pedal. Check for
g.
drag marks on the clamp surface along the side ledge. If present, add
foils behind the side ledge.
h.
If foils were added, check the clearance between the knife and the
clamp by performing procedure 5-20.1.
i.
Turn main power switch to O position.
5-20.23 Bleed the Hydraulic
System.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS:
Flat Tip Screwdriver
22 mm Combination Wrench
10 mm Combination Wrench
Flashlight
Rags (Item 21, Appendix E)
SUPPLIES:
Hydraulic Fluid (Item 12, Appendix E)
NOTE
Steps a. through d. are completed with power off.
Remove front electronics enclosure cover and right pillar cover.
a.
5-285