TM 5-3610-253-14
Using two adjusting screws located on either side of mounting pedestal,
j.
move glass rule from side to side until pencil mark on OMI screen
coincides with edge of projected graduation marks.
k. Clean glass rule with glass cleaner and cheesecloth.
Turn off power.
l.
Turn main power switch to O position.
(1)
Lock safety lock with operator key.
(2)
Rotate or Replace Cutting Stick.
MOS: 83F, Photolithographer
TOOLS: Flat Tip Screwdriver
Soft Face Hammer
SUPPLIES:
Cutting Stick
WARNING
Death or serious injury may occur from electrical shock unless power is
turned off before servicing.
CAUTION
Use care when removing or installing cutting stick to avoid damaging bed
groove.
a.
Turn off power.
(1) Turn main power switch to O position.
(2) Lock safety lock with operator key.
b. Insert screwdriver under end of cutting stick and carefully pry upward.
c.
Remove cutting stick from groove.
d. Rotate cutting stick to new position or replace with new stick.
5-78
