TM 5-3610-253-14
Remove front electronics enclosure cover and right pillar cover.
(1)
Remove capnut from clamp safety pressure relief valve.
(2)
Loosen locknut and rotate hex socket adjusting screw right to
(3)
increase pressure or left to decrease pressure.
Repeat step f. as necessary until pressure is 21 bar (298 psi).
(4)
Tighten locknut on clamp safety pressure relief valve.
(5)
Reinstall capnut.
(6)
Reinstall front electronics enclosure cover and right pillar
(7)
cover.
Turn main power switch to O position.
g.
Remove manometer from bleed port.
h.
Reinstall bleed port cap onto bleed port.
i.
5-278
