TM 5-3610-253-14
Remove front electronics enclosure cover.
ag.
ah.
Remove right pillar cover.
Remove frame mounting bolts.
ai.
aj.
Reinstall right pillar cover.
Remove HP card cover.
ak.
Remove frame mounting bolts.
al.
Reinstall HP card cover.
am.
Reinstall front electronics enclosure cover.
an.
Repeat steps y. through aa. to lift defective paper cutter off of support
ao.
frame. Be sure to insert backgauge table support leg before setting
defective paper cutter down.
Using a crow bar, lower clamp and remove wood board.
ap.
Refer to Service Upon Receipt for assembly of new paper cutter
aq.
Using a crow bar, lower clamp of new paper cutter and insert a wood
ar.
board; then release clamp.
Remove rear electronics enclosure cover.
as.
Remove clamp foot pedal (paragraph 5-16.10).
at.
5-274
