TM 5-3610-253-14
Remove clamp foot pedal (paragraph 5-16.10).
p.
Reinstall rear electronics enclosure cover.
q.
r.
Remove clamp foot pedal cover.
s.
Remove center mounting bolts from floor mounts.
t.
Lay sheets of metal along the floor lengthwise in a path for use by the
hydraulic pallet.
u.
Place the forks under the center of the paper cutter.
WARNING
Serious injury may occur if inadequate number of personnel are used to
move the paper cutter. This equipment weighs 4083 lbs.
v.
Raise paper cutter up.
w.
Push paper cutter to the rear of the van as far as possible.
x.
Using a crowbar, lower the clamp and insert a board on top of the
clamp; then release the clamp.
Using a forklift, place a piece of board across the forks and
y.
move the forks under the clamp.
z.
Place rags along the table where the forks are to prevent damage to the
table.
aa.
Lift the paper cutter up with the forklift and remove the paper cutter
ab.
Remove upper mounting bolts from rear brace.
5-272
