TM 5-3610-253-14
3. HYDRAULIC RESERVOIR. Remove the main drive motor V-belts cover. Remove the
side reservoir cover and gasket located above the pump pulley. Using a fluid
evacuation pump, pump all hydraulic fluid out of hydraulic reservoir and into a 5
gallon pail. Service hydraulic oil filter (paragraph 5-20.6). To fill, simply pour
17 liters (4.5 gals) of hydraulic fluid (OHA) into the reservoir to bring the oil
level to the top of the sight glass. Perform a complete bleed of the hydraulic
system (paragraph 5-20.23).
5-12. REPAIR PARTS, SPECIAL TOOLS: TEST. MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
-
(TMDE); AND SUPPORT EQUIPMENT.
5-12.1 Common Tools and Equipment. For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
5-12.2 Special Tools: Test, Measurement, and Diagnostic Equipment: and Support
Equipment. Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
5-12.3 Repair Parts. Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-3610-253-24P covering organizational maintenance for
this equipment.
NOTE
Minimum of four persons are required to service the paper cutter.
a.
The following sequence of steps are used to unpack the crate.
NOTE
The frame is mounted on two skids. The table is secured between wood
beams and the table brake protected by a wood crate. Individual
parts and accessories are packed in a wood box.
wood blocks Lift the crate approximately 10 cm (4 in.) off the ground and place
under all four corners.
(2)
Remove nuts on the top of the crate and lift off the lid.
5-88
PIN:
058779-003
