TM 5-3610-253-14
Table 5-9. DIRECT/GENERAL SUPPORT TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
5. DURING KNIFE CHANGING, CLAMP MOVES UPWARD AFTER BEING LOWERED WITH PEDAL - Cont
(a) Repair or replace linkage as necessary.
(b) If linkage is not broken or disconnected, replace control valve
ROUGH FOOT PEDAL MOVEMENT.
6.
Check clamp control valve piston for free movement when pressed.
(a) If piston binds, replace control block (paragraph 5-20.2).
(b) If piston does not bind, free up control bar.
