TM 5-3610-253-14
SYMPTOM INDEX
PAGE
TROUBLESHOOTING PROCEDURE
CUTTING
Machine Does Not Cut Through Material . . . . . . . . . . . . . .
Knife Pulls Sheets Out From Under Clamp During a Cut. . . . . . .
Knife Carrier Runs Against Guiding Gibs at the Top . . . . . . .
CLAMPING
Clamp Moves Down Too Slowly During Cutting . . . . . . . . . . .
During Knife Changing, Clamp Moves Upward After Being Lowered . .
Rough Foot Pedal Movement . . . . . . . . . . . . . . . . . . . .
Hydraulic System is Noisy During Operation . . . . . . . . . . .
ELECTRICAL
Paper Cutter Power On, Main Motor Starts, All Else Inoperative.
.
When Using the Foot Pedal, The Clamp Does Not Operate at All .
.
Clamp Does Not Operate When Cutting Buttons are Depressed . . .
.
With Cutting Buttons Depressed, Cutting and Clamping are
Inoperative, Light Barrier Signal Lamp is Lit . . . . . . . .
.
BACKGAUGE
Basic OMI
Measurement Varies From Cut to Cut. . .
.
.
.
.
.
.
.
.
Backgauge
Does Not Operate Electrically Forward .
.
.
.
.
.
.
.
.
Backgauge
Does Not Operate Electrically Backward
.
.
.
.
.
.
.
.
Backgauge
Does Not Operate Manually . . . . . . .
.
.
.
.
.
.
.
.
Table 5-9. DIRECT/GENERAL SUPPORT TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. MACHINE DOES NOT CUT THROUGH MATERIAL.
Check clutch pressure as follows:
a.
Using operator key, unlock safety lock, turn main power switch to I
position and allow paper cutter to run for 30 minutes to stabilize
hydraulic fluid temperature.
b. Turn main power switch to 0 position.
