TM 5-3610-253-14
Table 5-9. DIRECT/GENERAL SUPPORT TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4.
CLAMP MOVES DOWN TOO SLOWLY DURING CUTTING - Cont
Remove bleed cap from clamp bleed port and connect manometer to port.
c.
Turn main power switch to I position.
d.
Press control power on switch.
e.
Using the foot pedal, lower the clamp and check clamp pressure. Pressure
f.
should be 21 bar (298 psi).
g. With minimum setting on clamp pressure adjust pedal, perform a cut
checking clamp pressure. Pressure should be 32 bar (455 psi).
5-213
