TM 5-3610-253-14
Adjust Table Stop Bolts and Limit Switches.
MOS: 83FJ6, Reproduction Equipment Repairer
PERSONNEL: Two persons are required to perform this procedure.
TOOLS:
17 mm Combination Wrench
Flat Tip Screwdriver
6 mm Hex Head Key Wrench
SUPPLIES: None
a.
Turn on circuit breaker.
b. Using operator key, unlock safety lock.
c.
Turn on power.
(1) Turn main power switch to I position.
(2) Press control power on switch.
NOTE
It will be necessary to manually move the backgauge using the backgauge
control knob to position tha backgauge to the stops.
d. Position the backgauge to 36-3/4 in.
WARNING
Always keep clear of moving parts while performing this task. Serious
injury may occur.
e.
Remove oil drip pans under the table spindle.
NOTE
It may be necessary to move the backgauge forward in order to adjust the
stop bolt.
f. Loosen locknut and adjust rear stop bolt to proper setting.
Repeat steps d. through f. until proper adjustment is obtained.
g.
5-197