TM 5-3610-253-14
o.
Move the backgauge away from the limit switch.
NOTE
It may be necessary to adjust the nylon cams to obtain proper adjustment.
To adjust cams, loosen two hex head bolts. Use care to only move the cam
you are adjusting.
Adjust the limit switch by loosening two screws at the front of the
p.
switch and move the switch in (to stop sooner) or out (to stop later).
Repeat steps m. through p. until proper adjustment is obtained.
q.
r.
Repeat steps m. through q. for remaining limit switches.
s.
Reinstall oil drip pans.
t.
Turn off power.
(1) Turn main power switch to 0 position.
(2) Using operator key, lock the safety lock.
(3) Turn off the circuit breaker.
MOS: 83FJ6, Reproduction Equipment Repairer
19 mm Open End Wrench
TOOLS:
Paper
SUPPLIES:
Turn on circuit breaker.
a.
b. Using operator key, unlock safety lock.
Turn on power.
c.
(1) Turn main power switch to I position.
(2) Press control power on switch.
d. Place a stack of paper approximately 29-1/2 in. x 22 in. and 3 in. in
height under the clamp. Position the backgauge so that 1/4 in. will be
cut off the paper. Cut the paper.
e.
Turn the paper 180 degrees and again trim 1/4 in. off the stack.
f. Jog the stack of paper tightly against the backgauge rakes. Perform
another cut, this time cutting off two inches of paper.
5-199
