TM 5-3610-253-14
c.
Turn on power.
(1) Turn main power switch to I position.
(2) Press control power on switch.
NOTE
Ream of paper must be even on all sides.
WARNING
Be sure personnel and foreign materials are clear of the cutting and
clamping area before pressing the cutting buttons. Death or serious
injury may occur.
Always keep the largest area of the material being cut behind the knife.
If the larger area is in front of the knife, it could fly up and serious
injury may occur.
d. Place ream of paper onto cutting table and position backgauge so that
approximately 0.20 cm (1/2 in.) of paper will be cut.
e.
Be sure the paper is fitted tightly against backgauge.
f. Lower clamp using clamp foot pedal.
Pressing both cutting buttons, cut paper.
g.
h. Release clamp foot pedal and raise clamp.
i. Take half of cut ream (under clamp) and turn it 180 degrees.
j. Place material on top of the remaining half in the machine making sure
both materials are resting accurately and tightly against the back-
gauge.
NOTE
The side on which the lower half of the ream is wider than the top half
is the side that the adjustment screw must be turned to the right. However,
the opposite screw always has to be turned back the same amount.
k. Loosen set screws on adjustment screws.
l. Adjust screws as necessary.
5-194
