TM 5-3610-253-14
m.
Remove retaining ring from mounting plate end.
NOTE
In the following step do not disassemble brake hub from mounting plate.
Remove output shaft springs and control collar assembly by rotating
n.
output shaft to right.
NOTE
If the anti-backup spring is to be replaced, perform the following steps:
Replace broken or defective anti-backup spring; then proceed to step t.
o.
Remove control collar from output shaft and spring assembly by pulling
p.
collar toward brake spring end.
Replacement spring may be used for either clutch or
Examine springs.
brake spring.
r.
Replace defective or broken spring.
NOTE
Both springs must seat firmly on shaft and be placed evenly on shaft.
s.
Slide control collar over output shaft and spring assembly from the brake
spring end. It will be necessary to extend brake spring with needle nose
pliers.
NOTE
If original brake spring is to be reinstalled, place tab in original slot.
Position tab on brake spring into any of nine slots in control collar
t.
assembly.
Assemble output shaft, springs, and control collar assembly to the
u.
mounting plate assembly by rotating output shaft in drive direction.
3-63
