TM 5-3610-253-14
b.
Loosen screw on rear belt guard and remove belt guard.
c.
Loosen motor bracket bolts to slacken V-belt.
d.
Raise motor bracket. Remove V-belt.
Remove hex head screw, washer, and pulley washer.
e.
f.
Remove hex nut, lockwasher, and anchor strap screw to disconnect anchor
strap from clutch plate.
Tag and remove female wire connectors from tabs on solenoid.
g.
h.
Note position of clutch. Swing anchor bracket clear to slide pulley
and clutch off shaft as unit.
Remove socket head screws and washers to release solenoid. Note
i.
position of actuator assembly and remove defective solenoid.
Install new solenoid.
j.
k.
Slide pulley and clutch on shaft in original position.
l.
Reconnect anchor strap with strap screw, lockwasher, and hex nut.
3-60
