TM 5-3610-253-14
NOTE
Smooth surface of ring faces brake hub.
v.
Reinstall retaining ring on output shaft at mounting plate end.
w.
Rotate output shaft in drive direction until full brake action occurs.
NOTE
Clutch spring tab must not engage collar slot at this time.
Rotate input hub in opposite direction from drive direction and slide
x.
hub on input shaft.
Select collar slot for clutch spring tab that will permit collar to
y.
rotate 3/8 in. to 1/2 in. (1O mm to 13 mm). Selection is made by testing
slots . If control collar does not have sufficient travel, move collar
toward input hub and rotate collar until brake spring tab alines with
new slot. Repeat steps until 3/8 in. to 1/2 in. (1O mm to 13 mm)
rotation is obtained.
NOTE
Smooth surface of ring faces shaft.
z.
Replace retaining ring on output shaft.
aa.
Replace drive pulley and secure with capscrews.
ab.
Slide pulley and clutch on shaft in original position.
ac.
Connect anchor strap with strap screw, lockwasher, and hex nut.
ad.
Push female wire connectors on solenoid tabs.
ae.
Reinstall pulley washer, washer, and hex head screw on driving pulley.
af.
Reinstall V-belt.
ag.
Press down on motor mount to tension belt.
NOTE
Approximately 1/4 in. (6.35 mm) deflection is required in V-belt.
ah.
Tighten motor bracket bolts.
3-64
