TM 5-3610-253-14
Remove hex head screw, washer, and pulley washer.
e.
f. Remove hex nut, lockwasher, and anchor strap screw to disconnect anchor
strap from mounting plate.
Tag and remove female wire connectors from tabs on solenoid.
g.
h. Note position of clutch; then swing anchor bracket clear to slide pulley
and clutch off shaft as unit.
Remove capscrews and washers on pulley and remove pulley.
i.
NOTE
When disassembling clutch/brake unit, always mark the spring tab location
with reference to which slot they go in if-the same springs are to be
used in reassembly.
Release actuator lever to engage clutch and release brake.
j.
k. Remove retaining ring from input hub end.
Remove input hub by rotating to right.
l.
3-62
