TM 5-3610-253-14
m.
Push female wire connectors on solenoid tabs.
n.
Reinstall washer, pulley washer, and hex head screw on pulley.
o.
Reinstall V-belt.
Press down on motor mount to obtain correct tension on V-belt.
p.
NOTE
Approximately 1/4 in. (6.35 mm) deflection is required in V-belt.
Tighten motor bracket bolts.
q.
Reinstall rear belt guard and tighten screw.
r.
s.
Plug in power cord.
Replace Clutch, Brake, or Anti-Backup Spring.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS: Cross Tip Screwdriver
Snap Ring Pliers
9/16 in. Combination Wrench
Needle Nose Pliers
Spring
SUPPLIES:
WARNING
Death or serious injury may occur from electrical 'shock unless power cord
is unplugged before servicing.
NOTE
Before beginning the following procedure, it is critical that you mark
the position of the upper drive bar on the head frame. The stitcher head
must-be at the top of-its stroke.
a.
Unplug power cord.
b. Loosen screw on rear belt guard and remove belt guard.
Loosen motor bracket bolts to slacken V-belt.
c.
Remove V-belt.
d. Raise motor bracket.
3-61
