TM 5-3610-253-14
Table 5-23. DIRECT/GENERAL SUPPORT TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
10.
MACHINE DOES NOT CUT THROUGH MATERIAL .
Check clutch pressure.
(a) If clutch pressure is incorrect, adjust clutch pressure
as necessary, (paragraph 5-40.57).
(b) If correct pressure cannot be obtained, replace P2 block
(c) If clamping pressure is also being affected, replace
hydraulic pump (paragraph 5-40.24).
11. KNIFE PULLS SHEETS OUT FROM UNDER CLAMP.
Step 1.
Check to see if clamp pressure buildup is retarded.
(a) If pressure buildup is retarded, bleed the hydraulic system
(b) If problem is not corrected, proceed to step 2.
Step 2.
Check space between knife carrier and clamp during full clamping
pressure and correct as necessary (paragraph 5-40.17).
12. KNIFE CARRIER RUNS AGAINST GUIDING GIBS AT THE TOP.
Step 1.
Visually check for the following damages:
a.
Bent connecting rod (paragraph 5-40.44).
b. Bent shaft on main drive gear (paragraph 5-40.46).
c.
Bent eccentric bolt (paragraph 5-40.46).
If any of the preceding parts are defective, replace, using
appropriate procedures.
