TM 5-3610-253-14
Reinstall cable box cover.
j.
k. Reinstall limit switch assembly.
l.
Install new wire ties as required.
Reinstall the rear electronics enclosure cover.
m.
Perform gear limit switch adjustments (paragraph 5-40.58).
n.
MOS: 83FJ6, Reproduction Equipment Repairer
PERSONNEL: Four persons are required to perform this procedure.
TOOLS: Flat Tip Screwdriver
24 mm Combination Wrench
22 mm Combination Wrench
19 mm Combination Wrench
5 mm Hex Socket Bit with 3/8 in. Drive
17 mm Socket with 3/8 in. Drive
19 mm Socket with 3/8 in. Drive
3/8 in. Drive Ratchet
Pry Bar
Ball Peen Hammer
1/4 in. Punch, 8 in. long
SUPPLIES: Main Drive Gear and Clutch Assembly
Liquid Gasket (Item 14, Appendix E)
Gear Oil (Item 10, Appendix E)
Pail
WARNING
Death or serious injury may occur from electrical shock unless power is
turned off before servicing.
Turn off power.
a.
(1) Turn Star-Delta switch to Y position, then to O position.
(2) Turn main power switch to O position.
(3) Using operator key, lock safety lock and keep key in your
b. Remove the cover over the gear limit switches.
Remove the nylon cams and washers/spacers.
c.
5-598
