TM 5-3610-253-14
d. With the foot pedal in its uppermost position, an air gap of O.O - 0.1
mm (0.0 - .004 in.) should exist between the plunger of the control
block and the adjusting cam. If not, then reposition the adjusting cam.
e.
Pushing the foot pedal down to its lowest position should move the
plunger in 12 mm (.47 in.). If not, then adjust the frontstop bolt on
the guiding rod.
f. With the foot pedal down to its lowest position, a gap of 0.5 mm (.02
in.) should exist between the switch cam and the switch. If not, then
adjust the switch as follows:
(1) Loosen two switch mounting screws and move up and down until 0.5 mm
(.02 in.) clearance is obtained.
(2) Tighten mounting screws.
Reinstall front and rear electronics enclosure covers.
g.
h.
Place operator key back into the safety lock.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS: 24 mm Combination Wrench
Turn on power.
a.
(1) Using operator key, unlock the safety lock.
(2) Turn main power switch to I position.
(3) Turn Star-Delta switch to Y position. After main motor has reached
full speed, turn switch to
position.
(4) Press control power on switch.
b. Move the backgauge forward or backward as required until the backgauge
position is displayed on the measurement display.
WARNING
Always keep clear of moving parts while performing this task. Serious
injury may occur.
c.
To increase the spring tension, turn the adjusting nut to the right.
This will increase the clamp return.
5-456
