TM 5-3610-253-14
c.
Turn on power.
(1) Turn main power switch to I position.
(2) Turn Star-Delta switch to Y position. After main motor has reached
full speed, turn switch to
position.
(3) Press control power on switch.
d. Move backgauge forward or backward as required until backgauge position
is displayed on measurement display.
e.
Pull out clamp pressure adjustment knob.
WARNING
Be sure personnel and foreign materials are clear of the cutting and
clamping area before pressing the cutting buttons. Death or serious
injury may occur.
NOTE
Measurement display flashes 888.88, indicating knife changing operations
and backgauge operations are blocked.
f. Step on clamp foot pedal and lower clamp to approximately 3/4 inches
(19 mm) above the table.
Pressing both cutting buttons, lower knife.
g.
h.
Remove two knife retaining screws on the left side.
i.
Pressing both cutting buttons, raise knife to its upper position.
5-437
