TM 5-3610-253-14
Loosen locking nuts on connecting rod.
s.
t. By turning the turnbuckle, adjust the knife carrier to position which
allows the gage indicating pin to aline with the boring hole.
Tighten locking nuts on connecting rod.
u.
WARNING
Be sure personnel and foreign materials are clear of the cutting and
clamping area before pressing the cutting buttons. Death or serious
injury may occur.
Raise the knife carrier by pressing both cutting buttons.
v.
Lower the knife holding device again by using the T-Handle key.
w.
WARNING
Use extreme care when handling the knife. The knife is extremely sharp
and death or serious injury may occur from failure to observe this warning.
x.
Using knife carrying handles, place knife onto the knife suspending
bolts.
Raise the knife holding device.
y.
z.
Lower the knife by pressing both cutting buttons.
aa. Insert the knife retaining screws starting from the center to the
outsides, and tighten screws with T-Handle key.
ab. Pressing the cutting buttons, raise knife.
ac. Insert one right-hand knife retaining screw and tighten.
5-440
