TM 5-3610-253-14
ORGANIZATIONAL TROUBLESHOOTING - Cont
Table 5-21.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
5. SLANTING CUT.
Step 1.
Check that backgauge is parallel to knife.
(a) If backgauge is not parallel to knife, adjust
backgauge (paragraph 5-36.15).
(b) If backgauge is parallel, proceed to step 2.
Step 2.
Check sledge guiding for play.
(a) If sledge guiding is loose, adjust as necessary (paragraph
(b) If malfunction persists, refer to direct/general support
maintenance.
6. ROUGH AND FUSED TOGETHER CUTS.
Check to see if knife is blunt.
(a) If knife is blunt, replace knife (paragraph 5-36.11).
(b) If malfunction persists, refer to direct/general support
maintenance.
