TM 5-3610-253-14
Table 5-21.
ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3.
OVERCUT DURING THE CUT.
WARNING
Be sure personnel and foreign materials are clear of the cutting and
clamping area before pressing the cutting buttons. Death or serious
injury may occur.
Always keep the largest area of the material being cut behind the knife.
If the larger area is in front of the knife, it could fly up and serious
injury may occur.
Step 1.
Install a new cutting stick. Make a cut without paper,
noting knife cut mark in cutting stick; then load cutter with a
stack of map stock approximately 63.5 mm (2 1/2 in.) in height.
-
Make a cut, checking the reason for the overcut as follows:
(a) If cutting stick receives a second line in front of
first marking, replace the knife (paragraph 5-36.11).
(b) If there is no second mark on stick proceed to Step 2.
