TM 5-3610-253-14
Table 5-21. ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3.
OVERCUT DURING THE CUT - Cont
Check that backgauge is square to knife carrier.
Step 2.
(a) If backgauge is out of square, adjust backgauge
(b) If malfunction persists, refer to direct/general support
maintenance.
4. UNDERCUT.
Check for dull or burred knife edge.
(a) If dull or burred, replace knife (paragraph 5-36.11).
(b) If malfunction persists, refer to malfunction 3, step 2.
