TM 5-3610-253-14
Table 5-21.
ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2.
BOTTOM SHEET OF MATERIAL IS CUT ONLY ON ONE SIDE OR NOT AT ALL - Cont
(2)
Using the handle, rotate the eccentric and lower the knife.
Tighten the locknut, and check with another cut.
(3)
NOTE
If eccentric cannot be adjusted enough to correct the problem, perform steps
(4) thru (7).
(4) Remove the eccentric cover.
(5)
Loosen the locknuts on the turnbuckle.
(6)
Turn the turnbuckle 1/4 of a turn, and then make a cut.
Continue to repeat steps (1) through (6) until problem is
corrected.
Tighten turnbuckle locknuts, and reinstall eccentric
(7)
cover.
5-397
