ARMY TM 9-6675-349-12&P
MARINE CORPS TM 11039A-12&P
(6) When ready to transfer, turn the BCU INPUT power switch to OFF (IPADS should remain
operational, running on internal IPADS batteries; all BCU LEDs will be extinguished).
(7) Disconnect IPADS ground vehicle power cable P1 from BCU input power connector.
(8) Using four persons, transfer IPADS frame assembly to the helicopter.
(9) Adjust location of IPADS frame assembly until positioned approximately as illustrated in figure 3-12.
The plumb bob arm must swing clear of the fuselage.
(10) Connect IPADS UH-60 power cable W116-2 P1 to BCU DC input power connector.
(11) IPADS operator will request crew chief to turn on Utility RECP 7.5 AMP circuit breaker. Turn BCU
INPUT power switch to ON. BCU external DC power indicator should illuminate.
NOTE
When the IPADS is mounted in the helicopter, the vehicle type must be changed
vehicle. This can be accomplished before or after transferring the IPADS to the
helicopter.