ARMY TM 9-6675-349-12&P
MARINE CORPS TM 11039A-12&P
3-33. Transfer From Ground Vehicle to UH-60 Helicopter with Rotor Stopped - Continued
1. From the rear of the IPADS, run the cable
horizontally to the seat on the starboard side of
the aircraft.
2. Run the cable vertically up the inside post of the seat
up to the bar that runs horizontally across the cabin
of the aircraft (support installation, troop seat upper
70500-02160-012).
At the bottom, middle and top of the troop seat
bar, wire tie the cable to the troop seat.
3. Run the cable across the support bar towards the
starboard side of the aircraft.
Where the cable turns right, to run across the
top of the bar, place a wire tie.
Six inches from that point install another wire
tie.
Where the cable bends to go forward, place
another wire tie.
