TM5-6675-326-14
6 - 6 . 2 . 2 7 M e r g i ng Volume Runs - Continued
(12) Set auto-scaler X MEMORY switch to 1.
(13) Set calculator OFF/ON switch to ON.
(14) Set calculator MAN/TRACE/NORM switch to NORM.
(15) Set calculator PRGM/RUN switch to RUN.
( 1 6 ) P r e s s f o l l o w i n g k e y s :
CAUTION
Hold magnetic cards by edge. Be sure hands are
c l e a n . G r e a se , o i l , o r o t h e r m a t e r i a l s c an
damage magnetic cards.
c. Load preprogrammed magnetic card (para 6-6.2.10), Program
I I , i n t o c a l c u l a t o r .
d.
Tape map or drawing to be measured to table.
e .
Select correct tracer arm length.
NOTE
The tracer arm length should be shortest one
possible that will allow entire shape to be
measured without moving the planimeter.
f .
If needed, aline planimeter with tracer arm selected (para
6 - 6 . 2 . 1 4 ) .
R e c o r d RT v a l u e .
NOTE
F a c t o r y d e t e r m i n e d RT value is given on Calibration
Record Sheet provided with equipment.
Alinement is
performed as a check.
g .
Key in horizontal and vertical scales of contour map or
photo and RT v a l u e .
( 1 ) K e y i n h o r i z o n t a l s c a l e , p r e s s
m“
( 2 ) K e y i n v e r t i c a l s c a l e , p r e s s
m“
(3) Key in RT v a l u e , p r e s s
-“
6-77
