TM5-6675-326-14
6-6.2.26 Standard Volume Run Using Contour Method - Continued
s. Move to next contour loop.
Release remote tracer switch.
Repeat steps q through r until desired volume is determined.
to
To change contour interval when next loop to be measured is
a t a d i f f e r e n t i n t e r v a l , k e y i n n e w i n t e r v a l . P r e s s f a n d
a .
u.
I f l a s t e l e v a t i o n i s n o t e v e n c o n t o u r i n t e r v a l , k e y i n v a l u e
f o r l a s t e l e v a t i o n . P r e s s
f and c.
Repeat steps q
through t.
v.
T o s t a r t n e w r u n , p r e s s B or f and b t o i n i t i a t e m e m o r y.
Repeat steps k through q.
6-6.2.27 Merging Volume Runs
a. Assemble QPS with planimeter.
b.
Activate QPS:
(1) Plug foot switch into ACCU input jack on back panel of
a u t o - s c a l e r .
(2) Plug remote tracer switch into PRINT input jack on
back panel of auto-scaler.
(3) Plug planimeter into E1 e n c o d e r s o c k e t o n b a c k p a n el
o f a u t o - s c a l e r .
(4) Plug power transformer cable into POWER supply jack on
back panel of auto-scaler .
( 5 ) P l u g p o w e r t r a n s f o r m e r c a b l e i n t o w a l l o u t l e t.
(6) Plug power cord into back of calculator.
( 7 ) P l u g p o w e r c o r d i n t o w a l l o u t l e t.
(8) Set encoder OFF/E2 / E1 switch on back panel of
a u t o - s c a l e r t o E1 .
(9) Set AUDIO/OFF switch on back panel of auto-scaler to
AUDIO.
(10) Set auto-scaler B/ACCU/A/OFF switch to A.
(11) Set auto-scaler MAN/AUTO switch to AUTO.
6-76
