TM5-6675-326-14
6-6.2.27 Merging Volume Runs - Continued
k .
l .
m.
n .
o .
p .
q .
r .
s.
t .
u.
v.
P r e s s I N I T . b u t t o n t o c l e a r c a l c u l a t o r.
Make practice trace to make sure tracer arm will cover area
in one operation.
Press CLEAR button to clear auto-scaler.
Key in starting elevation and press
Trace boundary line of contour loop with dot in lens tracing
assembly.
Stop when you reach starting point.
Press and hold down remote tracer switch to activate PRINT
command.
NOTE
l
C a l c u l a t o r w i l l p r i n t t h e f o l l o w i n g i n f o r m a t i on
after the first measurement.
* * * E l e v a t i on
l
Additional measurements will provide values
for intermediate volume and total volume.
0.00 Area of contour loop
0.00 Intermediate volume in cubic yards
0.00 Total volume in cubic yards
Press and hold down foot switch.
Reposition planimeter to
make measurement of next contour loop.
Release foot switch.
Repeat steps o through q for each consecutive loop measured
before merge.
To change contour Interval when next loop to be measured is
a t a d i f f e r e n t i n t e r v a l , k e y I n n e w i n t e r v a l , p r e s s a nd
a .
Repeat steps o through s for each of the independent
volumes, until all independent volumes have been measured.
Reposition planimeter for measuring merge volume, and repeat
steps o through s.
To measure next object, press , and repeat steps g through
s.
6-79
