TM5-6675-326-14
6-6.2.26 Standard Volume Run Using Contour Method - Continued
(9) Set AUDIO/OFF switch on back
AUDIO.
(10) Set auto-scaler B/ACCU/A/OFF
panel of auto-scaler to
switch to A.
(11) Set auto-scaler MAN/AUTO switch to MAN.
(12) Set auto-scaler X MEMORY switch to 1.
(13) Set calculator OFF/ON switch to ON.
(14) Set calculator MAN/TRACE/NORM switch to NORM.
(15) Set calculator PRGM/RUN switch to RUN.
( 1 6 ) P r e s s f o l l o w i n g k e y s:
CAUTION
Hold magnetic cards by edge. Be sure hands are
clean.
Grease, oil, o r o t h e r m a t e r i a l s c an
damage magnetic cards.
c .
Load preprogrammed magnetic card (para 6-6.2.10). Program
II, into calculator.
d .
Tape map or drawing to be measured
e .
Select correct tracer arm length.
NOTE
The tracer arm length should
t o t a b l e.
be shortest one
possible that will-allow entire shape to be
measured without moving the planimeter.
f .
If needed, aline planimeter with tracer arm length selected
( p a r a 6 - 6 . 2 . 1 4 ).
Record RT value.
NOTE
F a c t o r y d e t e r m i n e d RT value is given on Calibration
Record Sheet provided with equipment.
Alinement
is performed as a check.
g .
Key in horizontal and vertical scales of contour
photo and RT v a l u e.
( 1 ) K e y i n h o r i z o n t a l s c a l e , p r e ss
m=
map or
6-74
