TM5-6675-326-14
6-6.2.25 Point Counts With Point Counter Pen and Constants - Continued
( 3 )
( 4)
( 5)
( 6)
(7)
( 8)
( 9)
(10)
(11)
( 1 2)
(13)
( 1 4)
c . L o a d
Plug power transformer cable
back panel of auto-scaler.
Plug power transformer cable
Plug power cord into back of
into POWER supply jack on
i n t o w a l l o u t l e t .
c a l c u l a t o r .
Plug power cord into wall outlet.
Set encoder OFF/E2/ E1 s w i t ch
auto-scaler to OFF.
Set AUDIO/OFF switch on back
AUDIO.
Set auto-scaler B/ACCU/A/OFF
on back panel of
panel of auto-scaler to
switch to A.
Set auto-scaler MAN/AUTO switch to MAN.
Set auto-scaler X MEMORY switch to 1.
Set calculator OFF/ON switch to ON.
Set calculator MAN/TRACE/NORM switch to NORM.
Set calculator PRGM/RUN switch to RUN.
CAUTION
Hold magnetic cards by edge.
c l e a n . G r e a se , o i l , o r o t h er
damage magnetic cards.
Be sure hands are
materials can
preprogrammed magnetic card (para 6-6.2.10), Program I,
i n t o c a l c u l a t o r .
d .
Tape drawing or map to be measured to table.
e. When multiplying counts by one constant, key in constant,
p r e s s -1 and q .
f .
Press CLEAR button to clear auto-scaler.
g .
Using point counter pen, make point count.
h .
Press PRINT to obtain results of count.
i .
To make point count with two to four constants, follow steps
a through d.
6-72
